• Optically and acoustically signals
the events of a fire detection or
extinguishing control panel
• Actuation of up to 144 LED pairs,
single LEDs or relays
• Single or summary indication
parameterisable
• Connection to the INFO bus
• Easy parameterisation by means of
PC software PARSOFT
Description
The Remote Tableau Drive Unit PTU288-1 allows to op- Furthermore, the PTU288 has 5 freely parameterisable
tically signal events of a Fire Detection Control Panel control inputs.
Series BC216 or BC016, or of an Extinguishing Control
Panel Series LC216, on an optional synoptic remote The remote tableau drive unit is connected to the fire
tableau. In addition, a built-in buzzer signals the alarm detection control panel via the INFO bus. Auxiliary mo-
or fault condition of the control panel.
dules are not needed for connection to Control Panels
Series BC216. A Serial Interface Module SIM016-3 is
Up to 3 LED Display Fields LAB48 or LED Connection necessary for connecting the PTU288 to a Fire Detec-
Modules LAM48-1 can be connected to the remote tab- tion Control Panel Series BC016.
leau drive unit in any combination.
In accordance to the parameterisation, the LEDs can be The PC software PARSOFT is used to parameterise the
used to display the conditions of detectors, detector zo- remote tableau drive unit via the USB interface.
nes, actuations, actuation elements, alarming devices,
transmitting devices, extinguishing systems or flooding The componentry is prepared for direct installation into
zones as well as the most important system conditions the LED Display Tableau LAT288-1 or LAT288-1CE. The
of the fire detection control panel (e.g., summary alarm, componentry can also be mounted in any housing in the
fault condition or disablement condition). If needed, it is LST standard grid, using the supplied mounting parts.
also possible to combine several events into a summary
display.
Specifications
Operating voltage
Current consumption at 24V
Ambient temperature
Dimensions L × W × H
Weight
15 – 31VDC
typ. 15mA (without LED modules)
-20°C to +60°C
150 × 75 × 20 (mm)
76g
Order number
252012
Order name
Remote Tableau Drive Unit PTU288-1
Building Safety. Building Security.
A
© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27
PTU288-1_DBL_LST_EN_0804.PDF • PAGE 1
[email protected] • WWW.LST.AT • ALL RIGHTS RESERVED
LED Connection Cord
The 2-wire connection cord serves to connect light – have to be actuated.
emitting diodes or relays to the LED Connection Mo-
dule LAM48-1. The cord is needed if other than the At one end of the cord there is a connector which fits
pre-assembled LEDs are used, or if more than two Re- to the pin connector of the LED Connection Module
lay Modules RL58-1 or RL58-2 – which can be directly LAM48-1, and the other end of the cord is open.
connected to the LED connection module via flat cable
Specifications
Line length
2m
Order number
Order name
259013
Cord 2-Wire for LED Connection/10pcs. LED-LEITUNG-10
Building Safety. Building Security.
A
© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27
PTU288-1_DBL_LST_EN_0804.PDF • PAGE 3
[email protected] • WWW.LST.AT • ALL RIGHTS RESERVED
|